Original Accessories / Auxiliary Equipment; Operation; Additional Handle; Depth Stop - Parkside 311912 Translation Of The Original Instructions

Original accessories / auxiliary
equipment
■ Only use the accessories and additional
equipment which are specified in the
operating instructions and are compatible
with the appliance.

Operation

Additional handle

NOTE
► For safety reasons, you should only use this
appliance with the additional handle
attached.
► The appliance is fitted with an LED
This lights up red as soon as the appliance is
connected to the power supply.
This indicates that the appliance is connected
to the power and that it will turn on immedi-
ately if the ON/OFF switch is pressed
♦ Loosen the strap on the additional handle
turning it anticlockwise.
♦ Push the additional handle
the tool holder .
♦ Turn the additional handle
position.
♦ The locking positions on the additional handle
must now be pushed over the locking pin on the
spindle of the appliance.
♦ Turn the additional handle
to tighten it.
NOTE
► Move the additional handle
various locking positions depending on
your working position. Undo and lock the ad-
ditional handle

Depth stop

♦ Push the locking button for the depth stop
and keep it pushed in.
♦ Insert the depth stop
handle .
♦ Make sure that the teeth on the depth stop
point upwards and downwards.
│ GB │ IE │ NI │ CY
■ 6
.
in the direction of
to the required
clockwise again
into the
as described previously.
into the additional
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth.
♦ Release the locking button for the depth stop
to lock the depth stop

Fitting/removing a tool

WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance.
Fitting a tool:
♦ Before fitting a tool into the tool holder
grease it lightly.
♦ To insert, pull the locking collar
and insert the tool.
.
♦ Release the locking collar
tool holder
by
locked by pulling it. The system has radial play
because of the design.
Removing a tool:
♦ To remove the tool, pull the locking collar
backwards.
Quick-release chuck for round shaft
drill bits
WARNING!
Do not use the quick-release chuck
►
for hammer drilling or chiselling!
♦ Set the function selector switch
symbol .
Inserting the quick-release chuck for round
shaft drill bits:
♦ To insert the quick-release chuck
fig. A) pull the locking collar
Insert the quick-release chuck
♦ Release the locking collar
tool holder
locked by pulling it.
out until the distance
.
backwards
. This locks the
. Check that the tool is properly
to the drill
(see also
backwards.
.
. This locks the
. Check that the tool is properly
PBH 1050 B2
,