Selecting Parameters (Program A) - EWM Phoenix 401 Progress puls FKG Operating Instructions Manual

5.8.13.1 Selecting parameters (program A)

Changes to the welding parameters can only be made when the key switch is in
position "1".
Operating
element
m/min
m/min
099-005296-EW501
28.01.2013
Action Result
Change welding data display over to program
display.
n x
(LED PROG is on)
Select program number.
Display example: Program "1".
Select program sequence parameter
"Main program (P
n x
(LED is on)
Set wire speed.
(Absolute value)
Set arc length correction.
Display example: "-0.8 V" correction
(Setting range: -9.9 V to +9.9 V)
Select "Dynamic" program sequence parameter.
1 x (LED DYN
Set dynamic. (Setting range 40 to -40)
40: Arc hard and narrow.
-40: Arc soft and wide.
NOTE
)".
A
is on)
Design and function
MIG/MAG welding
Display
DYN
sec
sec
sec
sec
sec
Super-
puls
DYN
sec
sec
sec
sec
sec
Super-
puls
sec
sec sec
sec
sec sec
71