Manufacturer Approved Cleaning Materials
Datalogic recommends the use of the following cleaners on its products.
•
Hydrogen Peroxide (not to exceed a 3% solution)
•
Chlorine bleach (not to exceed a 0.25% solution)
•
Mild detergent and water
•
lsopropyl Alcohol (not to exceed a 70% solution)
Use of above cleaners in combination with each other is
not recommended and may constitute a health hazard.
Follow all specified safety precautions when using any
cleaning solution.
CAUTION
Under no circumstances should abrasive cleansers, abrasive pads,
caustic solutions or other harsh chemicals, including those listed below,
be used on any part of the scanner as they can cause damage which will
adversely affect scanning performance. Use of such materials, either
alone or in combination with other cleaning agents, will void the
manufacturer's warranty.
•
Ammonia solutions
•
Acetone
•
Benzene
•
Ethanolamine
•
Ethers
•
Ketones
18
MAGELLAN™ 1500I
APPROVED CLEANERS
!!DO NOT USE!!
•
Trichloroethylene
•
Toluene
•
Carbolic acid
•
Aromatic or chlorinated hydrocarbons
•
Aqueous or alcoholic alkaline solutions