Introduction; Component Checklist; General Requirements - Rointe ROME RWI080DHWC4 Instruction Manual

1. Introduction

Designed with the user in mind, this product is a high quality, unvented domestic hot water cylinder
with an enamelled steel tank. The product is suitable for domestic hot water systems where the cold
mains water supply has a maximum supply pressure of 0.9 MPa. Reduced performance is available
at lower pressures, but the product is not suitable for pressures lower than 0.15 MPa and a flow rate
of 20 litres per minute. The neccessary safety equipment to comply with all national legislation is
available for purchase from Rointe. The main features of this product are:
• 1.77" TFT Screen with personalisable background colours & touch control panel
• Enamelled steel tank
• Low consumption
• Anti-legionella and Water Heating Progress functions
IMPORTANT - Please read this Instruction Manual carefully to ensure correct operation. It is im-
portant that the installer reads and understands these instructions and unpacks and familiarises
themselves with the equipment before commencing the installation. This manual must be left with
the product after installation. Failure to observe these installation instructions could render the guar-
antee null and void.
2. Component check list
The product comes with the following components. Please check through the components supplied
and ensure that all parts are present:
• Product with sheathed heating elements, digital thermostat, TFT screen and manual reset ther-
mal cut-out.
• T/P valve 0.7 MPa 90ºC and electrolytic fittings.
• Installation kit and user manual.
Please contact our Technical Service department on 0203 321 5929 to find out how to acquire
the safety fittings.

3. General requirements

3.1. Building regulations
The domestic hot water cylinder MUST be installed by a competent person in accordance with
section G3 of the current Building Regulations.
3.2. Important
It is important that the installer reads and understands these instructions and unpacks and
familiarises themselves with the equipment before commencing the installation. Failure to observe
4