Danfoss living connect Installation And User Manual
Electronic radiator thermostat
Hide thumbs
Also See for living connect:
- Quick start manual ,
- Installation and user manual (56 pages) ,
- Datasheet (8 pages)
Subscribe to Our Youtube Channel
Related Manuals for Danfoss living connect
Summary of Contents for Danfoss living connect
- Page 1 Installation and User Guide living connect® Electronic Radiator Thermostat Danfoss Heating Solutions VIIDH102 11/2013...
-
Page 2: Table Of Contents
Resetting living connect® to default settings ........ - Page 3 Connecting living connect® to Danfoss Link™ CC ........
-
Page 4: Installation
UK, CZ, SK, RU, TR, HU, HR, SI 1.2 In the package living connect® 014G0001 is supplied with a pre-mounted adapter for Danfoss RA valves, two alkaline AA batteries, a 2 mm Allen key and a Quick Guide in languages English, German, Danish, Dutch, French, Polish, Swedish and Finnish. -
Page 5: Overview Of Valve Adapters
Installation Guide living connect® 1.3 Overview of valve adapters Adapters for a wide range of different valve types are available as accessories. Adapter type Code no. Adapter Valve For Danfoss 014G0251 RA valves For M30 x 1.5 (K) 014G0252 valves... -
Page 6: Installing The Right Adapter
Installation Guide living connect® 1.4 Installing the right adapter Adapter for RA valves (pre-mounted on 014G0001) Place the RA adapter on the valve as shown. Tighten the adapter with the 2 mm Allen key. Adapter for M30 x 1.5 (K) valves Place the K adapter on the valve as shown. -
Page 7: Inserting The Batteries
After approx. two weeks the symbol will flash 14 times from 19:00 to 21:00 hrs. Before the batteries run out living connect® will leave the valve in a slightly open position to protect the valve from damage. 1.6 Using the buttons living connect®... -
Page 8: Installing Living Connect
During the first night of operation living connect® will shut off the radiator heat and then open again to detect the exact opening point of the valve. This will allow living connect® to control the heat as efficiently as possible. If necessary, the proce dure is repeated once a night for up to a week. -
Page 9: Removing Living Connect
Remove the battery cover and the batteries. Insert the Allen key or similar into the hole to lock the adapter ring. Turn counterclockwise to unscrew living connect® from the adapter. 1.10 Resetting living connect® to default settings Remove the battery cover and take out one Press and hold for approx. -
Page 10: Removing An Adapter From Living Connect
Installation Guide living connect® 1.11 Removing an adapter from living connect® Remove the battery cover. Insert a small hex key or similar into the locking hole to lock the adapter ring. With the hex key locking the adapter ring, Put back the battery cover. Mount living con- turn the adapter in the shown direction. -
Page 11: Technical Specifications
Installation Guide living connect® 2. Technical specifications Thermostat type Programmable electronic radiator valve controller Recommended use Residential (pollution degree 2) Actuator Electromechanical Display Grey digital with backlight Software classification Control Transmission frequency / range 868.42 MHz / up to 30 m Power supply 2 x 1.5 V alkaline AA batteries... -
Page 12: Overview Of Display And Control Buttons
4. Connecting living connect® to a Danfoss Link™ system 4.1 Configuring rooms in Danfoss Link™ CC Make sure that the room in which living connect® has been installed, has been configured in Danfoss Link™ CC - see installation guide for Danfoss Link™ CC. - Page 13 “No” to continue. 8. Once a device has been registered and the Radiator Con guration Danfoss Link™ CC is placed in final posi- Here you can con gure how the radiators are placed: tion, you must perform a network test - Visible Radiators see installation guide for Danfoss Link™...
-
Page 14: Testing The Connection
User Guide living connect® 4.3 Testing the connection Press for at least 3 seconds If no connection can be Press until LI is displayed. until M is displayed. made, the alarm and antenna Press to make the connec- symbols will both be flashing. -
Page 15: Open-Window Function
5.3 Automatic valve exercising To keep the radiator valve functional and at its best, living connect® automatically exercises the valve every Thursday at approx. 11:00 hrs by opening it fully and then return to normal setting. - Page 16 Installation and User Guide living connect® Installer Danfoss A/S Haarupvaenget 11 DK-8600 Silkeborg Denmark Phone: +45 7488 8000 Fax: +45 7488 8100 www.danfoss.com www.living.danfoss.eu VIIDH102 Produced by Danfoss A/S © 11/2013...
Need help?
Do you have a question about the living connect and is the answer not in the manual?
Questions and answers