Table of Contents
Advertisement
(10) Remove the stamp unit cover. (One screw)
(11) Remove the ground terminal. (One screw)
(12) Mount the stamp in stamp unit.
Note:
Align the round pin of the stamp with the slit in the
stamp unit side.
Y118120-9
Ground terminal
E-17
(13) Install the stamp unit and the ground terminal.
(One screw removed in step (11))
Note:
Tighten the unit together with the ground terminal.
(14) Connect the stamp unit connector to the main
body relay connector.
(15) Store the relay connector at the position shown
in the illustration and pass the stamp unit har-
ness through the gap of the rib.
Note:
Make sure that the harness does not interfere with
the roller.
Connector
(16) To install the covers and other parts removed in
steps (3) to (10), reverse the removal proce-
dure.
Ground terminal
Stamp unit
Rib
Installation Manual
Advertisement
Table of Contents
