Configure Your Device; Basic Settings; Replace The Lens; Adjust The Image - Axis Q1645 User Manual

AXIS Q16 Network Camera Series

Configure your device

Configure your device

Basic settings

Set the capture mode
1. Go to Video > Installation > Capture mode.
2. Click Change.
3. Select a capture mode and click Save and restart.
See also Capture modes on page 51.
Set the power line frequency
1. Go to Video > Installation > Power line frequency.
2. Click Change.
3. Select a power line frequency and click Save and restart.
Set the orientation
1. Go to Video > Installation > Rotate.
2. Select 0 , 90, 180 or 270 degrees.
See also Monitor long and narrow areas on page 10.

Replace the lens

1. Stop all recordings and disconnect power from the device.
2. Disconnect the lens cable and remove the standard lens.
3. Attach the new lens and connect the lens cable.
4. Reconnect the power.
5. Log in to the device's web interface and go to Video > Image > Exposure.
6. Select the P-Iris lens you have installed.
Note
If you use a DC iris, manual iris or optional i-CS lens there is no need to select a lens driver.
7. For the changes to take effect, you need to restart the device. Go to Maintenance and click Restart.
8. Adjust the zoom and focus.
Note
For a lens with P-Iris, DC-iris, or manual iris, manually adjust the focus on the lens before you fine-tune the focus through
the web interface.

Adjust the image

This section includes instructions about configuring your device. If you want to learn more about how certain features work, go
to Learn more on page 50.
6