Connectors - Axis Q1645 User Manual

AXIS Q16 Network Camera Series
Specifications

Connectors

Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
Audio connector
• Audio in – 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
• Audio out – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active
speaker with a built-in amplifier. A stereo connector must be used for audio out.
Audio input
1 Tip
Balanced microphone (with or without phantom power)
or line, "hot" signal
Audio output
1 Tip
Channel 1, unbalanced line, mono
The internal microphone is used by default; the external microphone is used when connected. You can disable the internal
microphone by connecting a plug to the microphone input.
I/O connector
Use the I/O connector with external devices in combination with, for example, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (12 V DC output), the I/O connector provides the interface to:
Digital input - For connecting devices that can toggle between an open and closed circuit, for example PIR sensors, door/window
contacts, and glass break detectors.
Digital output - For connecting external devices such as relays and LEDs. Connected devices can be activated by the VAPIX®
Application Programming Interface, through an event or from the device's web interface.
6-pin terminal block
Function
DC ground
DC output
Pin Notes
1
2 Can be used to power auxiliary equipment.
Note: This pin can only be used as power out.
2 Ring
Balanced microphone (with or without phantom
power) or line, "cold" signal
2 Ring
Channel 1, unbalanced line, mono
59
3 Sleeve
Ground
3 Sleeve
Ground
Specifications
0 V DC
12 V DC
Max load = 50 mA