Toshiba MMW-UP0271LQ-E Service Manual page 30

Confirming the indoor unit addresses and the position of an indoor unit using the remote
controller
Confirming the numbers and positions of indoor units
To know the indoor unit addresses though position of the indoor unit is
recognized
When the unit is individual (the indoor unit is paired with a wired remote controller one-to-
one), or it is a group-controlled one.
<RBC-AMT >
(Execute it while the units are running.)
1
Push the
2
UNIT LOUVER
Push the button (left side of the button).
1-1
A unit numbers
shows the system address and indoor unit address of the unit.
When 2 or more indoor units are connected to the remote controller (group-controlled units), a number of
other connected units appears each time you push the
NOTE:
The LED on the P.C. board of the selected hot water module flashes. The hot water module for change
settings can be confirmed.
<RBC-ASCU11 >
There is no such function in the remote controller.
TEMP.
FILTER
RESET TEST
button if the units stop.
is indicated on the LCD (it will disappear after a few seconds). The indicated number
CODE No.
No.
UNIT
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
UNIT LOUVER
button (left side of the button).
– 30 –
1
Starts
running
2