Table of Contents
Advertisement
3.
CONFIGURATION
3.1.
Methods
The SRC-64 can be configured by different methods below. We recommend
configuration by the web interface because it's most obvious and allows you to do
channel-wise routing, but basic configuration is also available via the front panel.
For automation purposes, the SRC can also be configured on the command line
(telnet or serial).
◆ Front panel
Clock source selection and interface-wise routing is available through the front
panel:
MVR-mkII: Use the Source and Domain A/B buttons in the "Clock/SRC" group.
MVR-64: Enter the "Clock" menu, move the cursor to ☼ ASRC and push OK to
enter SRC configuration.
◆ Web control
Configuration via the web interface is the recommended method. This enables you
to route arbitrary channels through the SRC up to its full capacity.
◆ Command line
The SRC can be fully configured via the command line. Refer to the MVRs
command line description, or type "help" at the command prompt.
SRC-64
7
Advertisement
Table of Contents
Need help?
Do you have a question about the multiverter SRC-64 and is the answer not in the manual?