Table of Contents
Advertisement
User's Manual
◆ Command line
Clock source selection:
clock A|B [<source> [<srate>|<smux>]]
Available Sources: AES3,ADAT,MADISFP1,MADISFP2,MADICOAX,DANTE,FLEXLINK
(*)
Samplerate (only required for DANTE or INTERNAL):
44100,48000,88200,96000,176400,192000
SMUX (only required for AES3,ADAT,MADI*,AES50TP* in TP mode,WCLK): 1,2,4
SRC configuration / Clock assignment:
asrc enable|disable [<in> <out>]: Configures the ASRC.
disable
enable
<in> <out>
* Available interfaces differ on the MVR-64. Type "help" in the command line to see a list of available values.
12
Turn off ASRC
Turn on ASRC, using previously set parameters or
those specified below:
Turn on ASRC, using previously set parameters or
those specified below:Interfaces which should run on
the alternate clock B. Possible Values:
AES3ADAT,MADISFP1,MADISFP2,MADICOAX,
AES50TP1,AES50TP2,DANTE1,DANTE2,
FLEXLINK1,FLEXLINK2,FLEXLINK3
(*)
Multiple values may be combined with comma, e.g.
MADISFP1,MADISFP2
'
NONE
If '
' is specified, the ASRC is turned off for the
respective direction. If both <in> and <out> are
NONE
set to '
' the ASRC is turned off.
<in>
Alternatively,
and
combined hex bit-mask, e.g.
0x0001=AES3ADAT
(
(*)
*
'
<out>
can be specified as
0x0400=FLEXLINK3
...
)
Advertisement
Table of Contents
Need help?
Do you have a question about the multiverter SRC-64 and is the answer not in the manual?