Playback On The Tv; Copying/Connecting To Other Devices; Connecting To A Computer - Sony HXR-NX30N Operating Manual

A photo cannot be captured from a
movie.
The recording media where you want to save

photos is full.

Playback on the TV

Neither image nor sound is played on the
connected TV.
Images are not output from the HDMI OUT

jack, if copyright protection signals are
recorded in the images.
The top, bottom, right, and left edges
of images are trimmed slightly on a
connected TV.
The LCD screen of your camcorder can

display recording images across the entire
screen (full pixel display). However, this may
cause slight trimming of the top, bottom, right,
and left edges of images when played back on
a TV which is not compatible with full pixel
display.
It is recommended you record images using

the outer frame of [Guide Frame] (p. 75) as
a guide.
The image appears distorted on the 4:3
TV.
This happens when viewing an image

recorded in the 16:9 (wide) mode on a 4:3 TV.
Set [TV Type] correctly (p. 83) and play back
the image.
Black bands appear at the top and bottom
of the screen of the 4:3 TV.
This happens when viewing an image recorded

in the 16:9 (wide) mode on a 4:3 TV. This is
not a malfunction.
Copying/Connecting to other
devices
Images are not copied correctly.
You cannot copy images using the HDMI

cable.
The A/V connecting cable is not connected

properly. Make sure to connect the cable to the
input jack of another device (p. 52).

Connecting to a computer

The computer does not recognize the
camcorder.
Disconnect devices from the USB jack of the

computer other than the keyboard, mouse,
and your camcorder.
Disconnect the Built-in USB Cable from the

computer, and restart the computer, then
connect the computer and your camcorder
again in the correct order.
When both the Built-in USB Cable and the

USB jack of the camcorder are connected
to the external devices at the same time,
disconnect one that is not connected to a
computer.
Movies cannot be viewed or copied to a
computer.
Disconnect the Built-in USB Cable from the

computer, and turn on your camcorder, then
connect the cable again.
You need to install the supplied "Content

Management Utility" to copy movies from
your camcorder to your computer (p. 56).
The computer freezes.
Disconnect the Built-in USB Cable from the

computer, and restart the computer, then
connect the computer and your camcorder
again in the correct order.
US