Marantz RC9200 User Manual page 47

8 Tap Save and assign a label to the macro.
The macro is ready to be used.
There are two extra commands you can record as any step in a
macro:
Recording a Device Action (Source Switching or Input)
To record a Device menu item containing a source switching com-
mand, open the Device menu, hold down the Right button (labeled
Action) and tap the device you want to switch to. This action places
the entire Device Action in the Macro.
Note If a macro has been recorded as a Device Action, you can inclu-
de all of it as a single step in another Macro, effectively nesting
one macro inside another. However, the last step of any Device
Action is a jump to the Device s Main panel. This step is not
included in the nested macro.
Jumping to a device control panel
To jump to any device panel, first navigate to the device you want
(using the Device menu), then select the exact device panel you
want (using the scroll arrows-not the tab buttons), then open the
Device menu, hold down the Left hard button (labeled Device) and
tap the device you want. After you ve recorded a jump, check your
Edit window. You ll see that you recorded both a jump and a device
action. If you do not want the device action, delete it.
Editing macros
You can edit any macro you have recorded.
1 Open the macro group that contains the macro.
2 Switch to Edit mode via the Mode button
3 Tap the macro you want to edit.
The contents of the macro appear.
4 Edit the macro.
You can move or delete listed commands, or you can record
new commands.
You can also add delays to the macro (for example, to insert a
short pause between turning on a device and sending com-
User Guide
45
Reference
.