D-Link DIR-825+ User Manual page 85

Section 3 - Configuration
Address Autoconfiguration Settings
Enable Automatic Enable or disable the Automatic IPv6 Address Assignment feature. If
you disable this option, no further configuration is available.
IPv6 address
assignment:
If you enabled DHCP-PD in LAN IPv6 Address Settings, you may enable DHCP-PD for the
LAN:
Enable Automatic Enable or disable the Automatic IPv6 Address Assignment feature
for the LAN.
DHCP-PD in LAN:
Autoconfiguration Select SLAAC+RDNSS, SLAAC+Stateless DHCP, or Stateful DHCPv6.
Type:
If you choose SLAAC+Stateless DHCP, the following field appears:
Router
The currently defined router advertisement lifetime is displayed.
Advertisement
Lifetime:
If you choose Stateful DHCPv6, please configure the following fields:
IPv6 Address
Enter the starting IPv6 address for the DHCP server's IPv6 assignment.
Range(Start):
IPv6 Address
Enter the ending IPv6 address for the DHCP server's IPv6 assignment.
Range(End):
Router The currently defined router advertisement lifetime is displayed.
Advertisement
Lifetime:
When you have finished configuring your IPv6 connection, click the Save Settings button.
D-Link DIR-825+ User Manual
IPv6 in an IPv4 Tunnel (continued)
ADDRESS AUTOCONFIGURATION SETTINGS
Use this section to setup IPv6 Autoconfiguration to assign IP addresses to the computers on your network.
☑
Enable Automatic IPv6 address assignment :
Autoconfiguration Type : SLAAC+RDNSS
SLAAC+Stateless DHCP
Stateful DHCPv6
Router Advertisement LIfetime :
Save Settings Don't Save Settings
ADDRESS AUTOCONFIGURATION SETTINGS
Use this section to setup IPv6 Autoconfiguration to assign IP addresses to the computers on your network. You can also enable DHCP-PD
to delegate prefixes for routers in your LAN.
☑
Enable Automatic IPv6 address assignment :
☑
Enable Automatic DHCP-PD in LAN :
Autoconfiguration Type : SLAAC+RDNSS
SLAAC+Stateless DHCP
Stateful DHCPv6
Router Advertisement Lifetime :
Save Settings Don't Save Settings
ADDRESS AUTOCONFIGURATION SETTINGS
Use this section to setup IPv6 Autoconfiguration to assign IP addresses to the computers on your network. You can also enable DHCP-PD
to delegate prefixes for routers in your LAN.
☑
Enable Automatic IPv6 address assignment :
☑
Enable Automatic DHCP-PD in LAN :
Autoconfiguration Type : Stateful DHCPv6
IPv6 Address Range (Start) :
IPv6 Address Range (End) :
Router Advertisement Lifetime :
Save Settings Don't Save Settings
ADDRESS AUTOCONFIGURATION SETTINGS
Use this section to setup IPv6 Autoconfiguration to assign IP addresses to the computers on your network.
☑
Enable Automatic IPv6 address assignment :
Autoconfiguration Type : Stateful DHCPv6
IPv6 Address Range (Start) :
IPv6 Address Range (End) :
Router Advertisement LIfetime :
Save Settings Don't Save Settings
▼
(minutes)
▼
(minutes)
▼
:00 1
:00 ff
(minutes)
▼
:00 1
:00 ff
(minutes)
81