Advertisement
Available languages
Available languages
To avoid overfilling the jug, the max level should be 0,8 liter. Use the level indicator on the
jug for reference. Place lid and inner cover on the jug before start. Check that the switch is in
"0" position and then plug the appliance. Turn the switch to desired setting for a few seconds.
Then turn back to "0" and check the consistency. The blender works fast so do not mix for too
long. The pilot lamp will shine during use.
Use pulse function (P) for shorter mixings. The switch must be kept in pulse position for the
blender to work. If you let go, the blender will turn off.
Mixing with warm liquid
The temperature of liquid to be used in the blender shall not exceed 75 °C. When preparing
warm soup or sauce, there may be a risk that the lid blast off and warm liquid splashes out
due to high pressure building up inside the jug. Do like the following to prevent this:
1.
Fill maximum half the jug with ingredients desired (such as for ex. vegetables, root
vegetables etc.)
2.
Start the mixer at level 1 or 2 (not Pulse-level) and thereafter slowly pour the liquid (warm
clear soup, cream or similar) through the hole in the black lid. Do not turn off the blender
while doing this. If the blender is switched off with warm liquid inside and then re-started,
there will be a pressure from the bottom due to high motor power that can result in the
lid blasting off.
If the blender have been switched off with warm liquid anyway during the above process, and
shall be started again, keep a pressure by placing a hand on top of the lid using a towel, a
pot-holder or similar, and watch out for possible splash of warm liquid.
Warm liquid alone must never be mixed since the pressure in the jug will be too high.
Important!
If frozen ingredients (such as fruit, berries or vegetables) shall be mixed, this shall be
done immediately after the ingredients have been put into the jug as they will otherwise
freeze to a firm lump. This may block the knife during use. Pour some more fluid into the
jug before starting the mixer.
It is possible to add more ingredients or fluid during use, but shut off the appliance first before
removing the lid or inner cover. Make sure that the ingredients to be added are not too heavy
for the motor to operate. Add some fluid to help the motor or stop the process and scrape the
ingredients from the jug with a spatula.
MAKE SURE THAT BOTH LID AND INNER COVER IS PLACED ON THE JUG BEFORE
STARTING THE APPLIANCE!
If you want to crush ice you should start with a small amount (max 8-9 cubes). Also
add a small amount of water to the jug before starting the appliance. Use the pulse
function.
20
Advertisement
