Installing A Remote Control Device On Analog Heaters; Wiring; Heater Settings; Installing A Remote Control Device On Digital Heaters - Raypak 5350 Installation And Operating Instructions Manual

22. INSTALLING A REMOTE
CONTROL DEVICE ON
ANALOG HEATERS

Wiring

For a 2-wire control, use the TOTAL and COMMON
connections on the heater wiring block.
For a 3-wire control, use the COMMON, SPA and POOL
connections on the heater wiring block.
Figure 12. Heater Wiring Block — Analog Heaters

Heater Settings

1. To operate the heater using a 2-wire remote control
device, simply switch the Spa-Remote-Pool knob
to the Remote position and make sure the heater is
enabled on the remote control device.
2. To operate the heater using a 3-wire remote control
device, simply switch the Spa-Remote-Pool knob to
the Remote position and set the temperature for pool
and spa.
24
23. INSTALLING A REMOTE
CONTROL DEVICE ON
DIGITAL HEATERS
Wiring
For a 2-wire control, use the TOTAL and COMMON
connections on the heater wiring block.
For a 3-wire control, use the COMMON, SPA and POOL
connections on the heater wiring block.
Figure 13. Heater Wiring Block — Digital Heaters
Heater Settings
1. Make sure the heater is disabled on the remote
control device. Then, push the SET key until POL
is displayed. Push the DOWN arrow key until OFF
is displayed. Wait until a temperature is displayed
before beginning the next step.
2. Push the SET key until SPA is displayed, then
push the UP arrow to 104°F (40°C). Wait until a
temperature is displayed before beginning the next
step.
3. Push the SET key until P_S is displayed, then push
the DOWN arrow until POL is displayed. Wait until a
temperature is displayed before beginning the next
step.
4. Finally, enable the heater on the remote control
device. When there is a call for heat, the heater
display will show SPA. When the heater is disabled,
the display will show POL.