Troubleshooting - Electrolux EWC1352 User Manual

18 www.electrolux.com
3.
10.8 The dangers of freezing
If the machine is exposed to
temperatures below 0°C, certain
precautions should be taken.
• Turn off the water supply.
• Unscrew the inlet hose from the
supply tap.
• Select a wash programme, start the
machine and let the programme run
for a short time.
• Interrupt the programme by turning
the programme selector to
position.
• Place the end of inlet and drain hoses
down low, into the waste gully (floor

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
11.1 Introduction
Certain problems are due to lack of
simple maintenance or oversights, which
can be solved easily without calling out
an engineer. Before contacting your
Authorised Service Centre, please carry
out the checks listed below.
During machine operation it is possible
that the pilot light blinks to indicate that
the machine is not working:
4.
20°
drain) set into the floor. Make sure
that the end of the hose does not go
below the water level in the gully's
(drain's) water tap.
• Select the programme "Drain" and let
it run until it is finished.
• Turn the programme selector to
position. When you intend to start the
machine up again, make sure that the
room temperature is above 0 °C.
The appliance is only to be used and
stored indoors at normal room
temperature. The manufacturer is not
responsible for any frost damage.
• 1 flash: problem with the water
supply.
• 2 flashes: problem with the water
draining.
• 4 flashes: door open.
Once the problem has been eliminated,
press the button Start/Pause
restart the programme. If after all checks,
the problem persists, contact your
Authorised Service Centre.
45°
to