Electrolux EWC1352 User Manual page 13

Synthetic and Wool programmes and
700 rpm for the Delicate wash
programme.
Rinse Hold
By selecting this option the water of the
last rinse is not emptied out to prevent
the fabrics from creasing. When the
programme has finished, the lights D and
E are lit to indicate that the water must
be emptied out (See: 'At the end of the
programme').
No Spin 0
By selecting this option all the spinning
phases are excluded. To be used for
extremely delicate material. The machine
will add some additional rinses to the
cotton and synthetic programmes.
For the maximum spin speed allowed by
each programme, refer to the chapter
'Programme Chart'.
8.5 Select the desired options
Depending on the programme, different
functions can be combined. These must
be selected after choosing the desired
programme and before pressing the
button . The relevant light will
illuminate.
Extra Prewash
Quick
If an incorrect option is selected, the
corresponding indicator lamp flashes for
about 2 seconds. For the compatibility of
the options with the washing
programmes, refer to the chapter
'Programme Chart'.
8.6 Starting the programme
To start the selected programme, press
the button Start/Pause
corresponding pilot light stops flashing
and remains on. On programme progress
display the pilot lights illuminate to
Easy Extra
Iron Rinse
; the
indicate that the appliance starts
operating and the door is locked.
8.7 Altering an option or a
running programme
It is possible to change any option before
the programme carries it out.
Before you make any change, you must
pause the washing machine by pressing
the button .
The programme can be changed as long
as the button has not been pressed.
Changing a running programme is
possible only by resetting it. Turn the
programme selector dial to
to the new programme position. Start the
new programme by pressing the button
again.
8.8 Interrupting a programme
Press the button
programme which is running, the
corresponding light starts to flash. Press
the button again to restart the
programme.
8.9 Cancelling a programme
Turn the selector dial to
cancel a programme which is running.
Now you can select a new programme.
8.10 Opening the door after the
programme has started
First set the machine to pause by
pressing the button
After some minutes, the door can be
opened, when the following conditions
are observed:
• The water temperature is below 55°C.
• The water level is below the bottom
edge of the door.
• The machine doesn't spin.
If you cannot open the door but it is
absolutely necessary to open it you have
to switch the machine off by turning the
selector dial to . After few minutes the
door can be opened. (Pay attention to
the water level and temperature!).
ENGLISH 13
and then
to interrupt a
position to
.