16 www.electrolux.com
11.6 Cleaning the inlet hose and the valve filter
1.
1
3.
11.7 Frost precautions
If the appliance is installed in an area
where the temperature can be less than 0
°C, remove the remaining water from the
inlet hose and the drain pump.
Do this procedure also when you
want to do the emergency drain.
1.
Disconnect the mains plug from the
mains socket.
2.
Close the water tap and disconnect
the water inlet hose.
3.
Disconnect the drain hose from a sink
or spigot
4.
Put the ends of the drain and inlet
hose in a container. Let the water
flow out of the hoses.
12. TROUBLESHOOTING
The start of the appliance does not occur
or it stops during operation.
2
3
2.
4.
5.
Set the Drain programme and let it
operate until the end of the cycle.
6.
Turn the programme knob to Stop to
disconnect the appliance from the
power supply.
7.
Disconnect the appliance.
WARNING!
Make sure that the temperature is
more than 0 °C before you use
the appliance again.
The manufacturer is not responsi-
ble for damages caused by low
temperatures.
90˚