Table of Contents
Advertisement
Proceed as follows to clean the pump:
1
4
13.11 Emergency drain
If the appliance cannot drain the water, carry
out the same procedure, described in
'Cleaning the drain pump' paragraph. If
necessary, clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent dispenser.
2. Start the programme to drain the water.
13.12 Frost precautions
If the appliance is installed in an area where
the temperature can reach values around 0°
C or drop below, remove the remaining water
from the inlet hose and the drain pump.
14. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
28
ENGLISH
2
5
1. Disconnect the mains plug from the
2. Close the water tap.
3. Put the two ends of the inlet hose in a
4. Empty the drain pump. Refer to the
5. When the drain pump is empty, install the
3
mains socket.
container and let the water flow out of the
hose.
emergency drain procedure.
inlet hose again.
WARNING!
Make sure that the temperature is higher
than 0 °C before you use the appliance
again.
The manufacturer is not responsible for
damages caused by low temperatures.
Advertisement
Table of Contents
