Using the Cylinder Lock (continued)
3. Slide the cylinder lock over the lift-cylinder rod
and secure with the cotterless pins.
Removing and Storing the Cylinder Lock
Remove the cylinder lock from the lift-cylinder rod and fully secure it in the storage
position before operating the machine.
1. Start the machine.
2. Fully raise the hopper.
3. Shut off the engine.
4. Remove the cotterless pins securing the
cylinder lock.
5. Place the cylinder lock on the posts inside the
machine frame and secure with the cotterless
pins.
6. Lower the hopper.
Lubrication
Greasing the Machine
Grease Type: General-purpose grease.
Note:
Remove the blue protection caps, if applicable, before greasing and replace when
finished.
1. Park the machine on a level surface and engage the parking brake.
2. Shut off the engine and allow the engine to cool.
3. Clean the grease fittings with a rag.
Maintenance: Pre-Maintenance Procedures
G324856
IMPORTANT
G324733
Page 5–5
3451-708 A