Table of Contents
Advertisement
Lubrication
Lubricating the Bearings and
Seals
Service Interval: After each use—Lubricate the trunnions.
Monthly—Lubricate the pillow-block bearings.
Note: The pillow-block bearings are inside the
cowl—remove the divider plate to access them; refer to
Removing the Divider Plate (page
Model 68024C does not have a divider plate.
Grease Type: No. 2 lithium grease.
1. Clean around each grease fitting with a rag and lift the
plastic cap off the grease fitting
1
1
2
3
Figure 43
1. Pillow-block bearings
2. Rear trunnion
28).
(Figure
43).
2
3
G020684
3. Front trunnion
2. Pump grease into each fitting as follows:
•
For the pillow-block bearings, pump 1 shot of
grease into each fitting
•
For the trunnions, pump several shots of grease
into each fitting until it starts to ooze out of the
bearing housing
Important: Pump grease in slowly and carefully
to prevent damage to the bearing seals.
3. Wipe up any excess grease.
G020685
29
(Figure
43).
(Figure
43).
Advertisement
Table of Contents
