Pre-Maintenance Procedures; Moving A Non-Functional Machine; Lifting The Machine - Toro 68141 Operator's Manual

Maintenance
Service Interval

Pre-Maintenance Procedures

Moving a Non-Functional Machine

Do not tow or pull the machine without first opening the bypass valves in this
procedure, or you will damage the hydraulic system.
Note:
Opening the bypass valves will ease moving the machine, but the tracks may still skid
due to their length and resistance.
1. If possible, raise the hopper and install the cylinder lock.
2. Shut off the engine and remove the key.
3. Using a wrench, turn the bypass valve on the left and right transaxles so that the flat
sides of the valve face left and right (Tow position
4. Tow the machine as required.
5. After repairing the machine, turn the bypass valves so that the flat sides face up and
down (drive position
6. Remove the cylinder lock and lower the hopper.

Lifting the Machine

Ensure that the hopper is empty before lifting the machine.
Maintenance: Pre-Maintenance Procedures
Maintenance Procedure
Change the hydraulic filter for the
lift and slew system.
).
Qty Description
Part No.
1-633750 1
IMPORTANT
).
g375754
Page 5–3
Filter
3451-708 A