Releasing The Cushion For Rear Access; Using The Cylinder Lock - Toro 68141 Operator's Manual

Lifting the Machine (continued)
1. Place the platform in the raised position.
2. Rotate the hopper and hoist the machine using
the lifting points.
Note:
to properly balance the unit.

Releasing the Cushion for Rear Access

1. Lower the platform.
2. Loosen the twist knobs
3. Remove the cushion
platform.
4. Perform any maintenance or adjustment on
the machine.
5. Raise the cushion, and slide it onto the pins on
both sides of the machine.
6. Tighten the twist knobs.

Using the Cylinder Lock

Installing the Cylinder Lock
1. Park the machine on a level surface, move the
motion-control levers to the N
position, engage the parking brake, and fully
raise the hopper.
2. Remove the 2 cotterless pins securing the
cylinder lock to the machine.
3451-708A
Take up the slack in the chain or straps
on each side of the machine.
and lower it to the
G324717
g032556
-
EUTRAL LOCK
G324733
Page 5–4 Maintenance: Pre-Maintenance Procedures