Toro 68141 Operator's Manual page 47

Drive Belt (continued)
7. Remove the 2 bolts and 2 nuts and loosen the 2 set screws on the coupler. Remove the
gear pump from the pump mount.
Note:
8. Remove the drive belt from the engine pulley and 2 transmission pulleys.
9. Route the new belt around the engine pulley and 2 transmission pulleys.
10. Install the gear pump.
11. Install the extension spring.
12. Install the fuel tank.
13. Raise the cushion.
3451-708A
You do not need to remove the fittings from the pump.
G189559
G189571
Page 5–20
Bolt (2)
Pump mount
Gear pump
Nut (2)
Engine pulley
Idler pulley
Transmission pulley (2)
Belt
Maintenance: Drive System Maintenance