Haul The Machine - Toro 68141 Operator's Manual

Raising the Hopper without Power (continued)
5. Disconnect the hose fittings in the manifold
block and allow the fluid to drain into the pan.
Note:
recycling center.
6. Use a hoist or have 2 people hold up the
hopper and install the cylinder lock.
7. After making repairs, install the hoses to the
manifold block fittings.
8. Add hydraulic fluid.
9. Remove and store the cylinder lock.

Haul the Machine

Use a heavy-duty trailer or truck to haul the machine. Use a full-width ramp. Ensure that the
trailer or truck has all the necessary brakes, lighting, and marking as required by law. Please
carefully read all the safety instructions. Knowing this information could help you or
bystanders avoid injury. Refer to your local ordinances for trailer and tie-down requirements.
Driving on the street or roadway without turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous and can lead to accidents causing
personal injury.
Do not drive the machine on a public street or roadway.
Selecting a Trailer
Loading a machine onto a trailer or truck increases the possibility of tip-over and
could cause serious injury or death.
• Use only full-width ramps.
• Ensure that the length of ramp is at least 4 times as long as the height of the trailer
or truck bed to the ground. This ensures that ramp angle does not exceed 15
degrees on flat ground.
3451-708A
Dispose of the used fluid at a certified
G384892
WARNING
WARNING
Page 4–11 Operation: After Operation