Silvercrest SSTMC 600 A1 Operating Instructions Manual page 17

■ To remove stubborn dirt, you can remove the attachment A with the cutting
blades 4 from the blender jug 3:
Fig . 3
1) Remove the blender 3 from the motor block 6 . For better stability, remove
the lid 2 by turning it anticlockwise towards the
until you can pull it off upwards .
2) Turn the appliance upside down and turn the attachment A anticlockwise so
that it can be detached from the jug of the blender 3 (see Fig . 3) .
3) Clean both parts in a mild soap solution or in the dishwasher .
NOTE
If necessary, you can remove the sealing ring B from the attachment A . Pull
the sealing ring B carefully out of the attachment A and clean it in a mild
soap solution . Rinse it off afterwards with fresh water .
4) Dry all parts thoroughly before reassembling them .
5) Replace the attachment A with the cutting blades 4 onto the blender jug
3 and turn it clockwise . Make sure the sealing ring B is inserted correctly .
■ 14 │ GB │ IE
A
B
position (see Fig . 1)
SSTMC 600 A1