Connections; Electrical Connection To Optional Main Wall Control - Venmar A180H75RT Series User's And Installer's Manual

3. CONNECTIONS

3.1 e c
lecTricAl onnecTion To
Always disconnect the unit before making any connections. Failure to cut power could result in electrical shock
or damage to the wall control or electronic module inside the unit.
Never install more than one optional main wall control per unit. Make sure that the wires do not short-circuit
between themselves or by touching any other components on the wall control. Avoid poor wiring connections.
To reduce the risk of electrical interference (noise), do not run wall control wiring next to control contactors or
near light dimming circuits, electrical motors, dwelling/building power or lighting wiring or power distribution
panel.
u
HD0491
Use the terminal connector included to perform the electrical connection for optional main wall control. Check if all wires are
correctly inserted in their corresponding holes in the terminal connector. Use screws to fix wires in the terminal connector.
Once the wall control connections have been made, insert the terminal connector in the electrical compartment.
NOTE : For information about the operation of the wall control, refer to the corresponding Installation and User Guide, available at
vanee.ca or venmar.ca.
3.1.1 e c
lecTricAl onnecTion To
VC0241
3.1.2 e c
lecTricAl onnecTion To
VC0242
o m w
pTionAl Ain
b v
niT oTTom iew
d A
eHumidisTAT or uTomATic
A o
dvAnced pTionAl
12V D- D+ Gnd
c
All onTrol
!
WARNING
CAUTION
o m w
pTionAl Ain All
12V
12V
D-
D-
D+
Gnd D+
Gnd
m w c
Ain All onTrol
12V D- D+ Gnd
11
T c
erminAl onnecTor
c
onTrol