Table of Contents
Advertisement
Screw specifications
M2.0 x L3.0
Remove the upper case
Make sure the following FRUs (CRUs) have been removed.
"Remove the deco cover" on page 30
"Remove the lower case" on page 31
"Remove the battery pack" on page 32
"Remove the solid-state drive (SSD) (on selected models)" on page 33
"Remove the solid-state drive (SSD) (on selected models)" on page 34
"Remove the thermal module" on page 34
"Remove the Wi-Fi card" on page 35
"Remove the DC-in bracket" on page 36
"Remove the I/O board" on page 37
"Remove the memory module" on page 38
"Remove the CMOS battery (on selected models)" on page 39
"Remove the CMOS battery (on selected models)" on page 40
"Remove the speakers" on page 40
"Remove the touchpad board bracket" on page 41
"Remove the system board" on page 42
"Disassemble the LCD module" on page 45
Go to
https://support.lenovo.com/partslookup
part:
Upper case
Disassemble the LCD module
The LCD module as a whole is not an FRU. Instead, it contains FRUs as its components. Before
disassembling the LCD module, make sure it has been detached from the upper case.
Remove the LCD bezel
Make sure the following FRU (CRU) has been removed.
"Remove the LCD module" on page 44
Step 1.
Remove the LCD bezel.
Note: The LCD bezel is fragile and should be replaced if damaged.
Number of screws
1
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
45
Advertisement
Table of Contents
