Figure 6. Remove the battery pack
Screw specifications
M2 x L4
Go to
https://support.lenovo.com/partslookup
replacement parts:
Battery pack
System mylar
Remove the solid-state drive (SSD) module
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
Step 1.
Disconnect the battery pack cable from the system board and then peel off the system mylar.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Remove one screw and then remove the SSD module by pulling it away from the slot.
Figure 7. Remove the SSD with SSD bracket
32
Hardware Maintenance Manual
Number of screws
5
to look up the Lenovo part numbers of the following