Connect Device To Networks; Installing The Cable Strain Relief - Siemens SIMATIC IPC227G Operating Instructions Manual

3.3.5

Connect device to networks

The following options are available for integrating the device in existing or planned system
environments and networks.
Ethernet
You can use the integrated Ethernet interfaces (10/100/1000 Mbps) for communication and
data exchange with automation devices, for example SIMATIC S7.
You need a suitable software to use this functionality: STEP 7, WinCC, SIMATIC NET.
Industrial Ethernet
You can establish a network between the device and other computers through Industrial
Ethernet. The on-board LAN interfaces are twisted-pair TP interfaces that support data
transmission rates of 10/100/1000 Mbps.
Note
You need a category 6 Ethernet cable for operation at 1000 Mbps.
PROFINET
PROFINET can be operated via:
• Standard Ethernet interfaces (RT)
SIMATIC NET
Use this software package to create, operate and configure an innovative network for Field &
Control level. Information on this can be found on the SIMATIC NET Manual Collection CD.
The software package and the documentation are not included in the product package.
Additional information
You can find additional information in Technical support. (Page 91)
3.3.6

Installing the cable strain relief

The cable strain relief plate carries the cables and prevents unintentional loosening of the
connector from the device. The cable strain relief is available as an accessory.
SIMATIC IPC227G
Operating Instructions, 07/2022, A5E50059933-AC
Installing and connecting the device
3.3 Connecting the device
33