Table of Contents
Advertisement
The thermostat display will show bnd, indicating it is waiting to see a reverse bind command from the L510. On the
L510, press its Bind/Service button to make the L510 send a Bind Request. The thermostat will send a Bind Offer to the
L510 containing the defined values when it sees this message. If the L510 received the Bind Offer, it would RESET and
upon startup, start using the new I/O Map configuration and send 3 Sound buzzer messages to make the thermostat
beep as an indication that the L510 was bound.
d. Press °F|°C three times to exit service mode.
4.
Test the functionality of the L510.
Binding and configuring the L510 from an E528/E527.4G or E529 Battery
Powered Thermostat
If not using EngINN to Bind and configure the L510, you can bind and configure the L510 with an E528/E527.4G thermostat or
E529 battery-powered thermostat. Refer to applicable commissioning documentation for the required L510 Address and I/O
Map.
1. Enter Service Parameter mode on the E528/E527/E529.
a. Press and hold °F|°C.
b. Press and hold OFF/AUTO.
c. Press and hold DISPLAY.
d. Release the three buttons.
The thermostat will display "rid" when it has entered Service Parameter mode.
2. If not already done, set the required Room ID, PAN ID, and RF Channel into the E528/E527/E529. These values will be
transferred to the L510 when you initiate the Bind. If these have already been set, skip to Step 3.
Set the Room ID:
a. With rid displayed, press DISPLAY. The currently stored Room ID value is displayed and will begin scrolling across the
screen from highest to lowest (left most to right most value). Note that the five-digit number comprises three fields:
highest digit, middle two digits, and lowest two digits.
b. Scrolling will stop at the highest digit first. HI, and will display the highest digit. Use the UP/DOWN arrow buttons to
change the value (range is 0-6).
For the E528/E527, press OFF/AUTO to continue. For the E529, press DISPLAY to continue.
c. It will display MED and the middle two digits. Set the following two values in the sequence using the UP/DOWN arrow
buttons (range is 0-99).
For the E528/E527, press OFF/AUTO to continue. For the E529, press DISPLAY to continue.
d. It will display the LO and the last two digits (the range is 0-99). Set the previous two values using the UP/DOWN arrow
buttons (range is 0-99) and press DISPLAY to accept the value.
e. The new ID number displays across the display. The E528/E527 stores the value in the memory beeps. The E529 does
not beep. It will show rid again once the scrolling is complete.
Set the PAN ID:
The valid ID range is 0-255; refer to the property-specific documentation for applicable PAN ID settings. To set the PAN ID, do the
following:
a. Use the UP/DOWN arrow buttons to select PAn.
b. Press DISPLAY
c. Use the UP/DOWN arrow buttons to select the valid PAN ID value.
d. Press DISPLAY to store the value in memory.
INCOMM L510 LAMP CONTROLLER USER GUIDE
9
v1.5 October 26, 2022
31-00593-01
Advertisement
Table of Contents
