Multy Device Access And Login - ZyXEL Communications WSQ60 User Manual

10.3 Multy Device Access and Login

I do not know the IP address of my Multy Device.
• The default IP address of the Multy Device in Standard Mode is http://Zyxelwifi.com or http://
Zyxelwifi.net.The default IP address of the Multy Device in Bridge Mode is http://(DHCP-assigned IP).
• If you changed the IP address and have forgotten it, you might get the IP address of the Multy Device
in Standard Mode by looking up the IP address of the default gateway for your computer. To do this in
most Windows computers, click Start > Run, enter cmd, and then enter ipconfig. The IP address of the
Default Gateway might be the IP address of the Multy Device (it depends on the network), so enter
this IP address in your Internet browser.
• If your Multy Device in Bridge Mode is a DHCP client, you can find your IP address from the DHCP
server. This information is only available from the DHCP server which allocates IP addresses on your
network. Find this information directly from the DHCP server or contact your system administrator for
more information.
• Reset your Multy Device to change all settings back to their default. This means your current settings
are lost. See
Device.
I cannot see or access the Login screen in the Web Configurator.
• Make sure you are using the correct IP address.
• The default IP address of the Multy Device in Standard Mode is http://Zyxelwifi.com or http://
Zyxelwifi.net.
The default IP address of the Multy Device in Bridge Mode is http://(DHCP-assigned IP).
• If you changed the IP address and have forgotten it, see the troubleshooting suggestions for
know the IP address of my Multy Device.
• Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
Start Guide.
• Make sure your computer is in the same subnet as the Multy Device. (If you know that there are
routers between your computer and the Multy Device, skip this step.)
• Reset the device to its factory defaults, and try to access the Multy Device with the default IP address.
See Section 2.4 on page
• If the problem continues, contact the network administrator or vendor, or try one of the advanced
suggestions.
Advanced Suggestions
• Try to access the Multy Device using another service, such as Telnet. If you can access the Multy
Device, check the remote management settings and firewall rules to find out why the Multy Device
does not respond to HTTP.
• If your computer is connected to the WAN port or is connected wirelessly, use a computer that is
connected to a LAN/ETHERNET port.
Chapter 10 Troubleshooting
Section 10.5 on page 228
30.
Multy WiFi System User's Guide
in the Troubleshooting for information on resetting your Multy
226
I do not