Table of Contents
Advertisement
3-4
•
A - Front passenger safety belt retractor (includes retractor pretensioner, adaptive load limiter and anchor pretensioner)
•
B - Front passenger safety belt buckle (includes buckle switch and Belt Tension Sensor (BTS))
•
C - Restraint Control Module (RCM)
•
D - C-Pillar side impact sensor
•
E - Driver safety belt retractor (includes retractor pretensioner and anchor pretensioner)
•
F - Driver safety belt buckle (includes buckle switch)
•
G - Driver front door side impact sensor
•
H - Seat position sensor
•
I - Occupant Classification Sensor (OCS)
•
J - Front impact severity sensor
•
K - Passenger Airbag Deactivation (PAD) Indicator
•
L - Passenger front door side impact sensor
Safety Belt Retractor
The safety belt retractors are located in the base of the B-pillars. The pretensioner located in the retractor is referred to as the safety belt
retractor pretensioner. In the event the RCM senses an impact, pretensioners provide improved occupant protection by rapidly removing slack
from the safety belt. Removing slack from the safety belt helps to properly position the occupant and allows for maximum effectiveness of the
safety belts and the air bags.
•
Do not use the safety belt retractor bolts for mounting the partition.
•
Do not mount any partition hardware on the inboard side of the B-pillar within the bottom 305 mm (12 in).
Do not mount any partition hardware that will interfere with the proper sealing of the door.
•
Section 3: Mounting
2019 Fusion Hybrid Modifiers Guide, 8/2018
Mounting
© Copyright Ford 2018 FoMoCo
Advertisement
Table of Contents
