Table of Contents
Advertisement
ASSEMBLY
• To watch an assembly
video, go to
www.freemotionfitness.
com/assembly or use
your mobile phone or
smartphone to read the
QR code at the right. A
reader application, such
as ShopSavvy, which
can be downloaded at www.shopsavvy.mobi, must
be installed on your mobile phone or smartphone.
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill or on the shipping
1. Make sure that the power cord is unplugged.
With the help of a second person, tip the tread-
mill onto its right side. Angle the Base (29) to
stabilize the treadmill.
Attach the Left Wheel Cap (87) to the Base (29)
with two #8 x 3/4" Screws (14).
Attach a Thick Base Pad (37) and a Thin Base
Pad (92) to the Base (29) with four #8 x 3/4"
Tek Screws (13). Make sure to attach the Thin
Base Pad (92) near the wheel as shown.
With the help of a second person, tip the tread-
mill onto its left side. Attach the Right Wheel
Cap (not shown) and the other Thick Base
Pad (37) and Thin Base Pad (not shown) as
described above.
carton. This is normal. If there is an oily substance
on the treadmill, wipe it off with a soft cloth and a
mild, non-abrasive cleaner.
• To identify small parts, see page 6.
• Assembly requires the following tools:
the included hex keys
one adjustable wrench
one Phillips screwdriver
scissors
needlenose pliers
To avoid damaging parts, do not use power tools.
1
13
37
29
37
7
14
13
92
87
Advertisement
Table of Contents
