Table of Contents
Advertisement
SSG-2029P-E1CR24H/L User's Manual
Assembling the Processor Heatsink Module (PHM)
After creating the processor package assembly, mount it onto the heatsink to create the
processor heatsink module (PHM).
1. Locate "1" on the heatsink label and the corner next to it. With your index finger
pressing against the screw at this corner, carefully turn the heatsink upside down with
the thermal grease side facing up.
2. Remove the protective thermal film if present. If this is a new heatsink, the necessary
thermal grease has been pre-applied in the factory. If the heatsink is not new, apply the
proper amount of thermal grease.
3. Holding the processor package assembly by the edge, locate the hollow triangle at the
corner ("a" in the drawing below), and note a hole and plastic mounting clips next to the
triangle. Also locate another set of mounting clips and a hole at the diagonal corner of
the of the processor package assembly ("b" in the drawing).
4. With the under side of heatsink and
the under side of the processor
package assembly facing up, align
the corner on the heatsink ("A" in
the drawing) against the mounting
clips next to the hollow triangle ("a")
on the processor package assembly.
5. Also align the corner ("B") at the
diagonal side of the heatsink with
the corresponding clips on the
processor package assembly ("b").
6. Once aligned, press the processor
package assembly onto the heatsink
until the mounting clips (at a, b, c,
and d) snap into place.
The processor heatsink module (PHM)
is created.
Processor Heatsink Module for the Processors
Non-Fabric CPU and Processor Clip
(Upside Down)
Triangle on the CPU
d
D
Triangle on the
Processor Clip
Heatsink
(Upside Down)
D
On Locations (A, B), the notches
snap onto the heatsink's sides
31
b
c
B
a
C
A
On Locations of (C, D),
the notches
snap onto the heat sink's
B
mounting holes
C
A
Make sure Mounting
Notches snap into place
Advertisement
Table of Contents
