Mitsubishi 800 Series User Manual page 52

5 PRE-OPERATION SETTINGS AND PROCEDURE
Number Name
Number of stations
occupied setting switch
3)
Indicator LEDs
L RUN
SD
4)
RD
L ERR.
5) Connector
6) Module fixing screws
Terminal block
1 3 5 7
7)
DA DG NC NC
2 4 6
DB SLD (FG1) NC
8) Rating plate
5 - 4
Used to set the number of occupied stations. (Factory setting:OFF(4 stations) )
Number
SW1
SW2
Data link status can be conformed by the on/off statuses of the LEDs.
LED Name
On:Indicates that communication is normal.
L RUN LED
Off:Indicates a communication break (time excess error).
SD LED On:Indicates data transmission.
RD LED On:Indicates data receive.
On:
L ERR. Flicker: Indicates that any switch (1 to 3) position was changed while
LED
Off:
Connector for connection to the GOT
Screws for installation to the GOT (M3 3 screw)
Terminal block for cable connection (M3 8 screw)
8
Get other manuals https://www.bkmanuals.com
Description
Switch Position
ON OFF
1 stations 4 stations
Must not be used
Description
Indicates a communication data error (CRC error).
power is on.
Indicates that communication is normal.
———
MELSEC-GOT
5 - 4