Mitsubishi 800 Series User Manual page 26

4 MONITORING SPECIFICATION
(2) When monitoring using the dedicated monitor method
Signal Direction : GOT
Device number
Number of occupied stations
2 station 4 stations
RXn0 to RXn0 to
RX(n+2)F RX(n+6)F
RX(n+3)0 RX(n+7)0
RX(n+3)1 to RX(n+7)1 to
RX(n+3)8 RX(n+7)8
RX(n+3)9 RX(n+7)9
RX(n+3)A RX(n+7)A
RX(n+3)B RX(n+7)B
RX(n+3)C to RX(n+7)C to
RX(n+3)F RX(n+7)F
• Do not output the reserved signals among the output signals provided from the
DANGER
4 - 8
Master module
Signal name
User area
GOT complete flag
Unusable
Initial data setting complete flag
Error status flag
Remote ready *1
Unusable
*1 The remote ready flag turns ON at GOT power-on, at hardware reset, or when the
GOT is in an operable state.
If the GOT has been powered on, the flag is OFF during offline operation (OS
installation, screen data downloading) or during initial processing execution.
Use this flag in an interlock ladder for write/read performed from the CC-Link master
station.
master module to the GOT.
If any of the reserved signals is output, the PLC system may malfunction.
Get other manuals https://www.bkmanuals.com
Signal Direction : Master module
Device number
Number of occupied stations
2 station 4 stations
RYn0 to RYn0 to
RY(n+2)F RY(n+6)F
RY(n+3)0 RY(n+7)0
RY(n+3)1 RY(n+7)1
RY(n+3)2 RY(n+7)2
RY(n+3)3 to RY(n+7)3 to
RY(n+3)8 RY(n+7)8
RY(n+3)9 RY(n+7)9
RY(n+3)A RY(n+7)A
RY(n+3)B RY(n+7)B
RY(n+3)C to RY(n+7)C to
RY(n+3)F RY(n+7)F
MELSEC-GOT
GOT
Signal name
User area
GOT request flag
GOT monitor request flag
GOT always write request flag
Unusable
Initial data setting request flag
Error reset request flag
Unusable
4 - 8