Mounting Procedure - Furuno SATELLITE COMPASS SC-33 Operator's Manual

1. MOUNTING
1.3

Mounting Procedure

Note 1: The bird-repellent fixtures (optional supply) can be attached to the antenna cover to
vent birds from landing on the cover. If it is more convenient to attach the bird-repellent fixtures
before securing the antenna unit to the mounting location, do step 6 below before fixing the an-
tenna unit.
Note 2: According to the installation location, connecting the antenna pig tale connector to the
NMEA2000 bus or a cable from an optional unit in advance is easy to fix to the location. Connect
a cable with reference to step 5 beforehand. Then, waterproof the connection.
1. As shown in the figure below, weld a platform (local supply) for which to mount the SC-33. The
thickness of the platform should be 5 mm to 15 mm.
Rear view
Vent hole
200
160
160
300
2. Orient the antenna unit to face the bow, referring to the figure above. The antenna should be
installed within ±2.5° of the bowline.
Note 1: Take care not to crush the cabling when mounting the antenna to the platform.
Note 2: Take care not to cover the vent hole on the antenna.
3. Secure the unit to the platform with four sets of M10 hex. nuts, spring washers and flat
washers (all included as installation materials) with 20 ±2 N•m torque.
How to fasten double nuts
Antenna unit
Platform
Torque 25 N•m
Flat washer
Spring
washer
Nut 1
BOW
Fixing hole (ø11 mm)
5 mm to 15 mm
Flat washer
Spring washer
Hexagonal nut (M10)
Nut 2
Torque 20 N•m
Nut 1&2 (Simultaneous work)
Nut1: Rotate slightly in opposite
Nut 2: Fixed in place.
8
pre-
Positioning the antenna cable
(Stern view)
Indent Indent
Cable Cable
direction to 1 .