Maintenance; Recommended Maintenance Schedule(S); Engine Maintenance; Servicing The Air Cleaner - Toro SGR-6 22600 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.
Important: The machine may be tipped backward or on its side to facilitate access for cleaning or service, but no
longer than 2 minutes. If the machine is held in this position for too long, the engine can be damaged by gasoline
draining into the crankcase. Should this happen, perform an extra oil change on the engine. Then turn the engine
over a few revolutions with the starter handle before starting the engine again.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 25 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Yearly or before storage
Important: Refer to your Engine Owner's Manual for additional maintenance procedures.

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Before each use or daily
The cyclone air filter collects the largest contaminant particles,
which collect in the container. When you can see a layer of
dirt at the bottom of the container, clean the cyclone housing,
air channels, and air intake screen.
Servicing the Cyclone Air Filter
Service Interval: Every 50 hours
1. Remove the 3 screws holding the cyclone housing.
2. Remove the housing with the air intake screen and
remove the air channels.
Maintenance Procedure
• Change the oil.
• Check the engine-oil level.
• Check the air filter.
• Check the condition of the teeth and rotate or replace any that are worn or damaged.
• Remove debris from the machine.
• Check the drive belt tension.
• Service the air filter.
• Change the oil.
• Clean the sediment cup.
• Check the spark plugs.
• Replace the air filter.
• Change the oil.
• Clean the sediment cup.
1. Cyclone housing
2. Screw
Note: The air channels may remain in the upper
portion or follow along with the housing when
removed.
3. Clean the components with water, detergent, and a
brush then dry the components carefully..
12
Figure 14
3. Air channels
4. Cyclone housing with air
intake screen