Vogt BP360 Service Manual page 29

Block will not compact
Block will not stay together
Block is too small, too light, or too wet
Compact hold delay will not adjust
Water injection timer will not adjust
Hydraulic pump squeals constantly
Hydraulic pump motor squeals
constantly
Hydraulic cylinders leak
Hydraulic cylinders squeal
Limit switch sequence not made
Oil pressure too low
Main cylinder will not extend
Compact hold delay (TDR-1) set to
"zero"
Compact hold delay (TDR-1) not
long enough
Water injection time (TDR-2) not
long enough
Volume not high enough on ice cut
off slide
Compact hold delay (TDR-1) too
long
Water injection time (TDR-2) too
long
Faulty timer
Faulty timer
Oil level too low
Bearings in pump damaged
Insufficient bearing lubrication
Bearings in motor damaged
Damaged or worn seals in cylinder
Damaged cylinder
Check that LS-4 has tripped
Check hydraulic fluid level in sump
and fill if low
See "Main cylinder will not extend"
Turn knob on TDR-1 to a position
above the absolute minimum
Turn knob on TDR-1 to a longer time
setting
Turn knob on TDR-2 to a longer time
setting
Adjust ice cut off slide to a higher
position
Turn knob on TDR-1 to a shorter
time setting
Turn knob on TDR-2 to a shorter
time setting
Replace timer
Replace timer
Fill hydraulic sump to fill line on
sight glass
Replace pump
Grease motor bearings
Replace motor
Replace seals
Replace cylinder
8-2