Operating Tips - Vogt BP360 Service Manual

press room, which is above freezing. Care should be taken to empty the supply system of all ice and snow prior to
shutting down the machine.

Operating Tips

•
By turning the main power switch to "OFF," the machine will halt production and return to its de-energized
state.
•
Throw the machine power supply disconnect only in an emergency or for safety reasons when performing
maintenance or other repairs to the machine.
•
The type of ice supplied to the block press is a key factor in the quality and size of block produced.
•
The ice cut-off slide can be adjusted to one of four height settings to control block size.
•
Ice block weight and quality can also be altered by the amount of water that is injected into the compacting
chamber during a cycle. Adjust the hand flow control valve and / or TDR-2 to find the correct setting for your
application.
•
Blocks formed from large or coarse ice fragments will benefit from the addition of water injection. This will
increase block weight and create a glazed surface to improve appearance and durability.
•
Blocks formed from fine ice or snow generally do not benefit from water injection, although a trace amount of
water may be necessary.
•
Excessive water injection may cause the block to melt inside of the compactor, resulting in smaller block size and
lighter weight.
5-2