Advertisement
CAUTION: Exhaust system can be extremely hot.
Let motorcycle cool down before
beginning installation. Always wear
hand and eye protection and take
precautionary measures to avoid
injury.
WARNING: Always properly support vehicle with
a stand and/or lift when servicing or
performing any work. Unstable
vehicles may present dangerous
conditions and may cause property
damage and/or personal injury.
NOTE:
Read through all instructions before
beginning installation.
Removal
1. Remove the stock heatshield to access muffler
exhaust clamp.
2. Loosen muffler exhaust clamp.
3. While securely supporting the stock muffler
assembly, remove the muffler mount bolt and
carefully remove the muffler.
4. Loosen the stock header clamp and remove
underslung muffler mounting bolt.
5. Remove the underslung muffler.
Note: If the motorcycle is equipped with a center
stand follow steps in the Factory Service
Manual to remove it before removing the
underslung muffler.
Installation
1. Install ALS-067, Aluminum spacer into the
backside of stock rubber grommet located in the
stock muffler mounting position.
2. Install 03019178, exhaust clamp onto
19140NS720-RMA slip-on muffler inlet. Do not
torque at this time.
3. Install muffler inlet onto header outlet and align
muffler bracket to the stock muffler mount. Secure
using M8X40, 8mm bolt, M8ALCSW-00,
aluminum countersink washer and 8MMNUT,
8mm flange nut, refer to diagram below.
4. Install YM5T-CFHS-SPCR, heatshield
spacers into 19140-CFHS-2, heatshield
shown below.
3
Advertisement
