Advertisement
5. Align and install 19140-CFHS-2,
heatshield onto the heatshield bracket using
RC116HSB-BK-P, 6mm button head screws
and 93412A423, rubber dampening washers
shown below.
Note: The rubber dampening washers are installed
between the heatshield bracket and
heatshield.
6. Loosen 19140-HS-CLMP, heatshield clamps
and install onto 19140-HS-BKT, heatshield
bracket with clamp screws in the orientation
shown below. Do not torque clamps at this time.
4
7. Install the heatshield assembly onto the stock
header.
8. Torque 03019178, exhaust clamp to
9.5 Nm (0.95 kg-m, 7 ft-lb).
9. Torque M8X40, muffler mount bolt to
23 Nm (2.3 kg-m, 17 ft-lb)
10. Torque 19140-HS-CLMP, heatshield clamp to
2.8 Nm (.028 kg-m, 2.08 ft-lb)
11. Before starting vehicle, check for proper
clearance between new exhaust system and
rear suspension (i.e. tire, swingarm, brakes,
rear shock, and etc.) If any problem is found,
please carefully follow through the installation
steps again. If problem still persists, please call
Yoshimura Tech Department at (800) 634-9166
/ in CA (909) 628-4722.
12. It is recommended that the muffler and tailpipe
be wiped down with rubbing alcohol to remove
oil and fingerprints. This will help prevent
tarnishing of the finish after the exhaust is
heated up.
Note: After starting vehicle, it is normal for new
exhaust system and muffler to emit
smoke until oil residue burns off.
Advertisement
