Function Selection Mode; What Is The Function Selection Mode; Factory Default Setting - SMC Networks D-MH1AD Series Operation Manual

Function Selection Mode

■What is the function selection mode?

In measurement mode, press the SET button for 3 seconds or longer but less than 5 seconds to display [F 0].
This [F□□] indicates the mode for changing each functional setting.
In function selection mode, press the SET button for 2 seconds or longer to return to measurement mode.

■Factory default setting

The factory default settings are as follows.
If there is no problem with these settings, use them as they are.
To change the settings, do so in function selection mode.
●[F 0] Switch output specification switchover/setting mode switchover functions
Item
NPN or PNP output
N.O. or N.C. output
Analogue display inversion
Output setting mode
: Depends on the part No.
●[F 1] How to set SP1
Item
Output point (SP1)
ON width (W_1)
Hysteresis (H_1)
Delay time (dt)
Display colour (CoL)
Factory default setting

NPN
N.O.
OFF
3 setting mode
Page 41
Description
Set the analogue value to switch output.
Set the ON range to the switch output.
Set an appropriate hysteresis to prevent chattering.
Select the delay time of the switch output.
: It is a common setting for SP1 to SP3.
Select the display colour.
: It is a common setting for SP1 to SP3.
-36-
Page 38
Factory default setting
----
(Not set)
50
20
0.00
(1.5 ms or less)
1SoG
(Interlocked with SP1)
: ON: Green
OFF: Red
No.D-※S-OMA1021