Cool/Dry/Fan Mode Operation Procedure - Mitsubishi Daiya SRK25RE1 User Manual

Page12
Page13
DISPLAY button
Press this button to set the disp-
lay on and off.
Fan
AREA
Press this button to set the air-
conditioning area in the room.
/ ECO
/ECO
Page15、 17
Page11
TIME SETUP switch
Switch for TIME SETUP
ACL
Econo display lamp
Indicates during ECONO mode
operation.
HI POWER display lamp
Indicates during HI POWER mode
operation.

COOL/DRY/FAN mode operation procedure

Aim the remote control at the air conditioner.
Press the
Press the
The screen is switched as shown below.
COOL, DRY, FAN
Select the desired operating mode
Press the TEMP button.
Press the
temperature.
It can be set among 18℃~30℃
Standard:
NOTE
The air is not blown out
Press the
duringthe operation.
Set the air flow rate as desired.
Operation condition of the air conditioner
Please use within the following operation scope,otherwise it will start the automatic prote-
ction device and resist the work of the air conditioner.
COOL operation
Outdoor temperature About 21℃to 43℃
Indoor temperature About 21℃to 32℃
It is about lower than 80%.When the equipment is used in the envir-
onment with more than 80% relative humidity, the dewing phenom-
Indoor humidity
enon on the surface of the equipment may be caused, thus, the water
drops are produced.
button.
button.
or button for the desired
button.
Press the button again.
RYD012A352