Table of Contents
Advertisement
COOL /HEAT/DRY/FAN mode operation procedure
CONT
AUTO
HI
MED
LO
ON OFF TIMER
FAN SPEED
ON/OFF
MODE
TEMP
AIR FLOW
SET TIMER
TIMER
ACL
Air flow direction adjustment procedure.
NOTE
• The air is not blown out during the operation.
Air flow direction adjustment procedure
I Up/down direction can be adjusted with the AIRFLOW button on the remote control. Each time when you press this button the mode
changes as follows:
Change to AIRFLOW mode.
AUTO
In COOL, DRY and FAN operation
Stops at the level
Sway operation
position for one
minute.
The flap operation as
shown above will be
repeated.
NOTE
• If the room temperature control (thermostat) switches to the heating mode or if the defrosting operation is on, the blow flap changes automatically to a horizontal
position.
• If the heating operation has just started and the room temperature is still low, it may take a while before the flap moves to the above sway operation angle.
• The flap may stop at the tilted down-blow position during the "sway operation" in the heating mode.
Aim the remote control at the air conditioner
1
2
3
4
Page 9
Page 16
Adjusting up/down air flow direction
or
(AUTO)
(SWING)
In HEAT operation
Sway operation
The flap operation
as shown above
will be repeated.
– 9 –
Press the ON/OFF button
Press the MODE select button
Move the [ ¡ mark] to the desirable operation position.
Heat Pump model:
(Cool),
Cool Only model:
(Cool),
Press the TEMP button
Press
or
button for the desired temperature.
Standard
• If CONT is selected, the room temperature is not controlled, as the operation is
then continuous.
Press the FAN SPEED button
Set the air flow rate as desired.
To stop:
Press the ON/OFF button.
Program changing procedure
Set the new program
•
The operation program can also be set or changed when the
air conditioner is not in operation.
No indication
(flap stopped)
SWING FLAP
Flap moves up and down
continuously
(Heat),
(Dry)
(Fan),
(Dry)
26°C~28°C
22°C~24°C
——
21°C~24°C
Hide quick links:
Advertisement
Table of Contents
