Table of Contents
Advertisement
Remote control handing procedure
Replacing the batteries
The following cases signify exhausted batteries.replace old batteries with new ones.
Receiving beep is not emitted when a signal is transmitted.
Indicator fades away.
Remove back lid and
Close the hack cover.
take out old batteries.
Insert new batteries.
The point of the ballp-
( AAA battery )
oint pen is used to re-
set the switch.
Setting mode of the d-
Attentton
isplay time.
to the and
marks
When the indicator shows any abnormal con-
NOTE
dition,press the reset switch with the tip of a
Don't use old and new batteries together.
ballpoint pen.
Remove the batteries when the remote co-
ntrol is not used for a long period.
On the battery is printed its expected life.
The life of a battery conforming to JIS or
This may be shorter than that of the batte-
IEC is 6 to12 months with normal use. If
ry, depending on the date of manufacture.
used longer, or when an unspecified batt-
However, the battery may still be in work-
ery is used, liquid may leak from the batt-
ing order after expiry of its nominal life.
ery,causing the remote control to malfun-
The old batteries must be well done.
ction.
Waring note for remote control handing
Don't go near high tempera-
Don't leave the remote con-
ture places,such as an elect-
trol exposed to direct sunli-
ric carpet or stove.
ght or other strong lighting.
Don't put any obstructing
Don't spill water etc on the
obstacles between the rem-
remote control.
ote control and the unit.
Notes for operating the switches.
When turning on the "CLEAN"
"Power save Operation" and
"reset" switch,please press it
vertically by a short tip (ballp-
oint pen,etc.).
Don't press it strongly from an
oblique direction by a long and
slender tip (propelling pencil,
etc.)which can cause the switch
does not reset.
Don't drop the remote con-
trol. Handle with care.
Don t put any weight on
the remote control.
When the operation fails with the remote control
Are the batteries running down?
If the operation still fails, handle as per
Replace the batteries with new
emergency run operation. Contact your
ones and repeat the operation.
dealer.
Operating hints
Please observe the following for the most economic and comfortable use of your unit.
Set a suitable room temp-
Clean the filters frequently.
erature.
Excessively high or low
Clogged filters may block the
temperatures are not good
air flow and cause less effici-
for your health and waste
ent operation.
electricity.
Adjust the airflow direction
Operate the unit only when
properly.
needed.
Adjust the up/down and l-
Use the timer properly to op-
eft/right airflow to ensure
erate the unit only when nee-
a steady room temperature.
ded.
Page21
Avoid direct sunlight and dr-
aught.
Cut out direct sunlight by dr-
awing the curtains or blinds
when cooling keep windows
and doors shut,except when
ventilating.
Generate little heat when
cooling.
Keep heat sources out of the
room as much as possible.
RYD012A352
Advertisement
Chapters
Table of Contents
