Fixed Mast Antenna; Audio Players; Cd Player - Chevrolet Low Cab Forward 2023 Manual

76 Infotainment System
notice fading and drifting, which increase
with the distance from the radio transmitter.
They are often accompanied by distortion.
Multi-path - FM signals are reflective,
making it possible for two signals to reach
your antenna at the same time. If this
happens, the signals will cancel each other
out, causing a momentary flutter or loss of
reception.
Static and fluttering - These occur when
signals are blocked by buildings, trees,
or other large objects. Increasing the bass
level may reduce static and fluttering.
Station swapping - If the FM signal you are
listening to is interrupted or weakened, and
there is another strong station nearby on
the FM band, your radio may tune in the
second station until the original signal can
be picked up again.
AM Transmissions
Fading - AM broadcasts are reflected by the
upper atmosphere, especially at night. These
reflected signals can interfere with those
received directly from the radio station,
causing the radio station to sound
alternately strong and weak.
Station interference - When a reflected
signal and a signal received directly from a
radio station are very nearly the same
frequency, they can interfere with each
other, making it difficult to hear the
broadcast.
Static - AM is easily affected by external
sources of electrical noise, such as high
tension power lines, lightning, or electrical
motors. This results in static.
Certification
For Federal Communications Commission
(FCC) compliance information for this device,
see Radio Frequency Statement 0 304.

Fixed Mast Antenna

Pull the antenna out to its full length when
using it.
To prevent breaking the antenna, shorten it
when passing through areas with low
clearance or through a car wash.

Audio Players

CD Player

CD Operations
Playing a Disc (When There is No CD
Inserted)
Insert a disc into the disc slot with the label
side (printed side) facing up. The power will
switch on and playback will start
automatically.
Playing a Disc (When There is a CD Inserted)
1. Press MODE/ /ENTER.
2. Turn MODE/ /ENTER to select DISC,
and then press ENTER.
Turning off the Player
Press POWER for one second or more. To
resume playback, press POWER again.
Ejecting the Disc
Press EJECT to stop playback and eject
the disc.