Table of Contents
Advertisement
70
Lighting
signal indicator lights flash to signal an
emergency. To turn off the hazard lights,
press the switch again.
Do not leave the hazard warning light
flasher operating for an extended time
period with the engine off. Otherwise, the
battery may go dead, making it impossible
to restart the engine.
Both indicator lights flash when the hazard
warning flasher switch is operated
irrespective of the position of the engine
control switch.
The individual turn signals do not work
when the hazard flasher is turned on.
Turn and Lane-Change Signals
An arrow on the instrument cluster flashes
in the direction of the turn or lane change.
Move the turn signal lever all the way up or
down to signal a turn.
Raise or lower the lever for less than
one second until the arrow starts to flash to
signal a lane change. This causes the turn
signals to automatically flash three times.
It will flash six times if Tow/Haul Mode is
active. Holding the turn signal lever for
more than one second will cause the turn
signals to flash until the lever is released.
The lever returns to its starting position
whenever it is released.
If after signaling a turn or a lane change the
arrows flash rapidly or do not come on, a
signal bulb could be burned out. If equipped
with LED turn signals, see your dealer.
Replace any burned out bulbs. If a bulb is
not burned out, check the fuse. See Electrical
System Overload 0 229.
Turn Signal On Chime
If the turn signal is left on for more than
1.2 km (0.75 mi), a chime sounds at each
flash of the turn signal. The message TURN
SIGNAL ON will also appear in the Driver
Information Center (DIC). To turn the chime
and message off, move the turn signal lever
to the off position.
Cornering Lamps
The cornering light illuminates the area to
which the vehicle is turning. With the
headlights or marker lights on, the cornering
lights come on in coordination with the turn
signal lights.
See Exterior Lamp Controls 0 68 and
Bulb Replacement 0 222.
Advertisement
Chapters
Table of Contents
